Overlap joining: Is used mainly at bend conveyors, special 2 or 3 ply belt types and when performing cold gluing. The endless belt is installed making sure that the lap will run with the scrapers and not against. Joining angle is 70 (90 is possible). read more
Megapoxy High Impact Crusher Backing is a two component pourable epoxy grout suitable for: Backing Crusher Parts Grouting Machinery Locking Bearings Setting Anchor Bolts Chocking of Machinery Description Part Ħ°AĦħ is a white low viscosity liquid and is packed in a re-sealable plastic bucket. Part Ħ°BĦħ is a blue coloured liquid and is packed in a screw capped plastic bottle. Accelerator is a clear brown liquid and is packed in a 250 ml. tin. Method of Use Seal all crevices with putty (such as Megapoxy PF Rapid set putty) so that backing mixture does not leak out. Make certain no settling has occurred in the resin by stirring, then add the hardener (Part Ħ°BĦħ) slowly with continual mixing. Using low speed electric drill, mix well, but do not aerate. Mix until uniform colour is obtained. The mixture must be used immediately after mixing. If ambient temperature is high, the kits should be stored in as cool a place as possible. High ambients will lead to greatly shortened usable life. If topping up is required, then this can be carried out at a later date when it is convenient. If adhesion is not required, one or both surfaces should be coated with wax or grease based release agent. Allow Megapoxy HICB to harden before returning crusher into service. read more